Model setup

This section is designed to let you customize and save settings for each model independently. Here you can edit the model name, set the throttle cut point, and adjust all channel parameters. Each change is stored in memory, so when you switch models, the previously saved configuration will load automatically.

Available options:

• Edit name

• Set throttle cut

• Channels Configuration

  • Failsafe

  • Exponential curves

  • Reverse

  • Endpoints

• Delete model

To adjust the selected model’s settings, access the Model Setup menu, from the home screen, press and hold the cursor click for a few seconds to open the main menu. Then, navigate using ← and → until you reach the Model setup option, and click to enter.

Edit Model Name

To modify the model's name, navigate to the option displayed as the current model name using ↑ and ↓. Once highlighted, press the cursor click to select it. A modal will be displayed showing the current name and a cursor.

Use ← and → to move the cursor between character slots and ↑ and ↓ to change the character. When you’re satisfied with the name, press the cursor click to confirm. To cancel, press and hold the cursor click for one second to close the dialog.

You can consult the LM-5X 5CH Receiver manual here

Receiver Binding

Binding is the process that pairs your handle with its receiver so they communicate exclusively—this ensures your signals control only your aircraft and prevents interference from other nearby transmitters. Once bound, the setting is stored permanently in the handle’s memory, so you only need to repeat it if you change the receiver on your aircraft.

To perform the binding:

1

Activate Bind Mode on the Receiver

Put the receiver into Bind mode (Turn on the receiver while pressing the binding button on it. You will see the light on the receiver start flashing blue).

2

Select the Binding Option

In the handle, navigate to the option bind using ↑ and ↓ and press the cursor button.

3

Initiate the Binding Process

A dialog appears indicating the handle is searching for a nearby receiver in Bind mode.

4

Confirm Successful Binding

If the receiver is correctly in Bind mode, binding is immediate: the receiver LED stops flashing and remains solid blue. And the binding dialog box on the handle will disappear.

5

Handle Binding Timeout

If no Bind-mode receiver is found, the process will automatically stop after several seconds of retries.

You can cancel binding at any time with a quick press of the cursor click.

Throttle cut

This function stops a combustion engine quickly and safely by moving the servo just beyond idle to close the carburetor. Holding the Throttle Cut button for 2 seconds shifts the servo to the menu’s preset cut position, sealing the carburetor and shutting off the engine. When you release the button, servo control returns to the trigger, but the engine remains off.

To modify this value, navigate to the option Throttle cut using ↑ and ↓. Once highlighted, press the cursor click to select it.

Adjust the throttle cut position using ↑ and ↓ ,holding the Throttle Cut button to preview the servo angle as you go.

Once you’re happy with the position, press the cursor click to save the new value.

Delete model

Use this option to permanently remove the selected model and all its settings.

Navigate to the option Delete using ↑ and ↓. Once highlighted, press the cursor click to select it.

When the confirmation dialog appears use ← and → to choose No (cancel) or Yes (delete).

After confirmation the model and its settings are erased and you’ll return to the Home screen with no model selected.