Flight parameters and Usage

The LM-T1 Timer offers a highly flexible and intuitive level of customization. Upon startup, it displays a menu with only two options:

• START

• SETUP

To navigate through the different options, there is a 3-position thumb switch: Up, Center, and Down on the right side of the timer. Moving Up and Down allows you to navigate through the options and/or adjust the parameter values, while clicking in the Center allows you to select an option or set a value for a parameter, as appropriate.

Usage

There are two ways to start the timer:

• In the main menu, select the START option and hold down the Center button for 2 seconds.

• Or hold down the external switch for 2 seconds (this operation can be performed from any menu).

You must hold the button down for at least 2 seconds to prevent accidental starts.

To confirm the start of the flight sequence, the motor will rotate one full turn as feedback. Once the flight sequence begins, you will see the icons corresponding to each stage on the screen. For more information, see the Status Icons section.

You can abort a flight sequence once it has started if necessary by holding down the center click or the external switch for 2 seconds.

The flight sequence consists of the following steps:

1

Delay

Time taken to reach the center of the circle and prepare for takeoff.

2

Takeoff

The acceleration curve begins as the defined RPM is reached.

3

Cruise flight

The acceleration percentage is maintained throughout the entire flight.

4

Landing alert

The motor temporarily reduces its RPMs as a form of feedback.

5

Landing

The motor begins to slow down until it comes to a complete stop.

When there are approximately 3 seconds left before the end of the flight duration defined in the parameter, there will be a sudden and noticeable deceleration of the motor to indicate that landing is about to begin, and it will automatically recover its previous speed until the end of the flight time. Once the landing sequence has begun, the engine will gradually decelerate for 10 seconds until it stops completely.

After this time, the flight sequence is complete.

Flight parameters

To adjust the flight parameters, you need to access the SETUP menu from the main screen. Use the Down button to select the SETUP menu, then click the Center button to access it.

This menu contains the following parameters to be adjusted:

• Delay

• Takeoff curve

• RPM

• Flight duration

Use the Up and Down actions to navigate between the parameters and use the Center click to select the one you want to adjust.

Understand what these parameters mean and how to configure them in the following sections.

All parameter values are stored in persistent memory, so the last configuration made will be saved.